When you install the Sentech SDK Package, the IP configuration software “GigECameraIPConfig_VC141_x64” will be installed.
If you do not change the installation path, the executable file will be copied to the following folder:

C:\Program Files\OMRON_SENTECH\SentechSDK\v(version)\Application

The fixed IP address can be set in decimal format by following the steps below.

1. Connect the camera and start “GigECameraIPConfig_VC141_x64.”
2. The Device Selection screen will appear.
   Select the camera and click OK.
3. The GigE Camera IP Config window will open.
   Check the “PersistentIP” option at the bottom right.
4. Enter the IP address and Subnet mask.
5. Uncheck “DHCP” and click “Apply.”
6. After completing the settings, start StViewer and confirm that the IP Address shown under Device Configuration on the Device Selection screen matches the IP address you set.