It is possible to go back to factory default settings with CLCtrl2 software by below procedure.
1. Selects “ReadAll” button.
2. Selects “Factory->EEPROM” button after finish read all parameters process.
3. Selects “EEPROM->Register” button.
* If without selec “EEPROM->Register” button, factory default settings are applying when power on camera next time.

Please use CLCtrl2 software to change camrea settings.
CLCtrl2 uses binary format for communication command.
The camera communication can be done with protocol specifications of product specifications.
The debug tool or communication monitring tool can be monitoring commands of CLCtrls to check communication data between camera and PC.

The administration permission is required when using virtual COM port with some Camera Link frame grabber board on 64bits environment.
Please runs CLCtrl2 with “As Administrator” when this error message occures.